Phone Dock (Moto G)

6 (likes)
2987 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Dock for Moto G phone. There is a fair amount of friction in the connector so the phone needs to be pressed down instead of just dropped into the dock. Requires the following parts 6-32 set screw, approximately 1/4 inches in length (to hold the cable in place - do not over-tighten) StarTech right angle USB Cable http://www.amazon.com/StarTech-com-Micro-USB-Cable-UUSBHAUB1RA/dp/B003YKX6WC (if you use a left angle cable, you will need to mirror the part. A few inches of 1.75mm NinjaFlex filament for the base (red in the pictures) This design tends to warp when using ABS, I'd recommend a non-warping plastic like PET or PLA.

About the author:
walterhsiao
3D printing addict. Printing with an Eustathios and Rigidbot 3D printers.

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.