Quixo Block

2 (likes)
2980 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Just a basic replacement Quixo Block.  Print with either the X or O side down and no support will be needed and no problem with drooping on the lettering. Lettering is inverse extruded (intruded?) deep enough to allow for a few coats of low build primer and then your whatever color coating and faux wood finish you choose. Printed at .15 layer height and although it does not need it,  30% infill to get close to approximate weight of original piece. Finished with low build primer, faux wood finishing, and hand applied lacquer. (All in all, I know I could have done it faster in actual wood, but that isn't the point.)

About the author:
BoozeKashi
Designer/Maker with a small but growing studio in Bangkok, Thailand. Love to make everything, working with two schools, and several university engineering student groups. Also printing parts for hobbyists and other makers all over Thailand. Enjoy designing new ideas, printing and finishing toys, and creating prototype pieces.

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.