Filled base for DIYnder v2

0 (likes)
19 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

This is a simple weighted base for the DIYnder which uses cement grout and old screws. It means you dfon't have to find a gym weight to fit over the standard base. Place an M6 nut in the slot and check the bolt will screw itno it. Fill the base section with old screws etc and add cement grout to fill the gaps. Vibrate it to get the air out. Then put the lid on with four M3 screws. Add more grout through the round hole, shaking it to distribute, until it is full. Make sure the space where the rack will fit is clear of grout, and let it set.  The rack will fit with herringbone facing upwards and can be tightened in place with the M6 bolt. If you need to screw the base down, there are four holes for screws in the corners. Thanks to Chris Borge over at Printables for the inspiration to fill it with grout. I printed using ordinary PLA, which seems fine for this purpose.

About the author:
oddplanet
Stop motion animator

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.